Drying and storing nylon
Nylon readily absorbs moisture from the air. A good drying and storage routine can make a big difference.
Why nylon needs extra care
Nylon is hygroscopic, which means it pulls moisture from the air. How quickly this happens depends on the type of nylon, the humidity where you live, and how the spool is stored. Some users find that drying a new, sealed nylon spool before use improves print consistency.
Signs your nylon may have absorbed moisture
- Popping, crackling, or hissing sounds at the nozzle
- Bubbles, pits, or a rough, fuzzy surface
- More stringing than usual
- Weaker or more brittle parts, or poor layer bonding
- Inconsistent extrusion
Drying nylon
Use a filament dryer, or another drying method your filament maker approves. Drying temperatures and times vary by nylon type and brand, and some makers specify settings in the range of about 70–90 °C for several hours. Always use the temperature and time your filament maker recommends, and stay within your dryer's limits and your spool's temperature rating.
Drying generally reduces moisture but can't be guaranteed to remove it all, and filament can start picking moisture back up once it is exposed to air again. If problems continue after drying, check the other causes in our troubleshooting guide.
Storing nylon
Moisture control is one of the most important variables in nylon printing. Consistent storage practices often have a greater impact on print quality than small adjustments to temperature settings.
- Seal it. Store spools in an airtight bag or container as soon as you finish printing.
- Add desiccant. Fresh or regenerated desiccant helps keep humidity low inside the container. Replace or recharge it following the maker's instructions.
- Use a humidity indicator if you can, so you know when the desiccant needs attention.
- Print from storage. A dry box that feeds filament to the printer helps limit moisture pickup during long prints.
Drying your printed parts?
Nylon parts also exchange moisture with the air after printing, which can affect their stiffness and size slightly. For parts with tight tolerances, test them in the conditions where they will be used.